Replacing Carbon Brushes - Makita HR3000C Manuel D'instruction

Masquer les pouces Voir aussi pour HR3000C:

Manuel d'instructions (56 pages)

Table Des Matières

Table des Matières

Les langues disponibles

Blow-out bulb (optional accessory)

After drilling the hole, use the blow-out bulb to clean the

dust out of the hole.

Chipping/Scaling/Demolition

Set the change lever and the shift lever to the

Hold the tool firmly with both hands. Turn the tool on and

apply slight pressure on the tool so that the tool will not

bounce around, uncontrolled. Pressing very hard on the

tool will not increase the efficiency.

Drilling in wood or metal

Use the optional drill chuck assembly. When installing it,

refer to "Installing or removing the bit" described on the

previous page.

Set the change lever and the shift lever to the

You can drill up to 13 mm (1/2") diameter in metal and up

to 30 mm (1-3/16") diameter in wood.

CAUTION:

•

Never use "rotation with hammering" when the drill

chuck assembly is installed on the tool. The drill

chuck assembly may be damaged.

•

Pressing excessively on the tool will not speed up

the drilling. In fact, this excessive pressure will only

002449

1. Blow-out bulb

003204

symbol.

003221

1. Drill chuck

assembly

symbol.

serve to damage the tip of your bit, decrease the

tool performance and shorten the service life of the

tool.

•

There is a tremendous twisting force exerted on the

tool/bit at the time of hole breakthrough. Hold the

tool firmly and exert care when the bit begins to

break through the workpiece.

•

Always secure small workpieces in a vise or similar

hold-down device.

MAINTENANCE

CAUTION:

•

Always be sure that the tool is switched off and

unplugged before attempting to perform inspection

or maintenance.