Necessary Tools; Throttle Reversing - Ultraflex B 310 Manuel D'installation Et D'entretien

ULTRAFLEX
3 INSTALLATION

3.1 Necessary tools

Phillips
screwdriver

3.2 Throttle reversing

THE B310 CONTROL IS SUPPLIED
WITH THE MECHANISM
ALLOWING ENABLING THE
ENGINE THROTTLE LEVER BY
PUSHING IT WHEN THE BOAT
SPEED INCREASES (SEE THE
DRAWING)
Engine throttle lever
PUSH OPERATING CABLE
NOTICE
This procedure is only necessary for throttle mechanisms that require a pull instead of push to open.
1 Make sure the
control is in the
neutral position
(rocker arm 1 as
shown in the
drawing).
page 8
of 63 -
SINGLE LEVER CONTROL B310
Open end
Pliers
wrench
10mm[0,395"]
1
Installation and maintenance manual
Punch
Ø 6 - 6,5 mm
[0,23"-0,25"] or
screwdriver
IF THE THROTTLE LEVER OF
THE BOAT MOTOR MUST BE
ENABLED BY PULLING IT,
WHEN THE SPEED INCREASES,
THE CONTROL THROTTLE
SYSTEM MUST BE MODIFIED TO
OBTAIN THE CONFIGURATION
SHOWN IN THE DRAWING
PULL OPERATING CABLE
2 Remove screw (2), washer (3). tube (4),
spring (5) and lever (6).
6
5
4
3
2
Drill