Lever Use; Neutral Warm-Up; Trim Operation - Ultraflex B 310 Manuel D'installation Et D'entretien

ULTRAFLEX

4 LEVER USE

4.1 Lever use
The lever travel includes two movements: in the first phase the shift gear is enabled; in the second one
the throttle is enabled. If the lever is in forward position, the boat moves forward; if the lever is in
backward position, the boat goes in reverse. To unlock the B310 control lever from the neutral position,
press the lever unit trigger (22) on the lower part of the handle and simultaneously move the lever
forward or backward.
DANGER
If the control has no safety switch, before starting the engine make sure that it is in neutral position.

4.2 Neutral warm-up

1 Pull lever hub in the direction shown by the arrow (23) and rotate
clockwise or counterclockwise until desired warm-up.
With lever in neutral. return spring will bring hub to initial position.

4.3 Trim operation

The trim allows changing the boat attitude.
By pressing the "UP" push button, the boat bow lifts; by pressing
the "DOWN" push button, it lowers.
page 18
of 63 -
SINGLE LEVER CONTROL B310
B310
SHIFT GEAR
Installation and maintenance manual
22
23