Temperature Setting; Malfunctions And Remedies - IARP JAZZ m. Instructions D'emploi Et D'entretien

Each refrigerating appliance is provided with a thermostat for automatic maintenance of the appropriate
pre-established temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user. Only if the
average internal temperature is too cold or not cold enough should the knob (1) turned.
The numbers on the regulation plate are not related to temperature values but only to knob reference
position: a higher number corresponds to a lower temperature.
0
2 1

MALFUNCTIONS AND REMEDIES

Most of the functioning inconveniences are generally due
to simple causes or to defective electrical connections.
These problems can usually be solved on site.
The unit does not start:
- check that there is voltage at the wall socket;
- check that the unit is properly plugged.
The internal temperature is not cold enough:
- check that the unit is not placed too close to any heating source;
- check that there is not too much ice on the evaporator;
- check the temperature setting;
- check that the condenser is not blocked by dirt.
The unit is noisy:
- check that all the bolts and nuts are properly fastened;
- check that the unit is placed on an even surface;
- check if any pipe or fan is in contact with any other part of the body.

TEMPERATURE SETTING

COLDER
2
1 3
4
7 5
6
Defrosting is executed automatically. The water generated by the eva-
porator, collected in a tray, soaks an absorbent cloth and is dissolved
by means of the heat lost by the cooling system.
Periodically check and clean the tray,removing dust and/or
residues, after extracting the support of the absorbent cloth.
INFORMATIONS ABOUT SERVICE
3
CONTROLS
1) Thermostat
2) Defrosting led light:
3) Light switch (if it is mounted)
-9-
alight during defrosting time