Optional Kits; Accessories; Packing And Unpacking; Unpacking, Moving, Use And Storage - Blastrac BDC122 Manuel D'instructions

Operating manual BDC-122 / BDC-122H

Optional Kits

Please contact the manufacturer's sales network for
information on optional kits.
Instructions for installing the optional are included in
the conversion kit.
Use only genuine optional kits supplied and
authorized by the manufacturer.
Optional kits must be installed by qualified
personnel.

Accessories

Various accessories are available; refer to the
manufacturer's accessory catalogue.
Use only genuine accessories supplied and
authorised by the manufacturer.

Packing and unpacking

Dispose of the packing materials in compliance with
the laws in force.
MODEL
BDC-122
BDC-122H
(*) Weight with packing
GB
WARNING!
WARNING!
Figure 3
A B C
mm mm mm
700 790 1500

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum
cleaner is placed on must be suitable for bearing its
weight).
Setting to work - connection to the
power supply
Make sure there is no evident sign of
■
damage to the vacuum cleaner before
starting work.
■ Before plugging the vacuum cleaner
into the electrical mains, make sure the
voltage rating indicated on the data plate
corresponds to that of the electrical
mains.
Connect the plug into a socket with
■
a correctly installed ground contact/
connection.
■ Make sure that the vacuum cleaner is
turned off.
The plugs and connectors of the
■
connection cables must be protected
against splashes of water.
■ Make sure that connections to the
electrical mains and plug are correct.
Use the vacuum cleaners only when the
■
cables that connect to the electricity
kg (*)
mains are in perfect condition (damaged
cables could lead to electric shocks!).
68
Regularly check there are no signs of
■
damage, excessive wear, cracks or ageing
on the electric cable.
When the device is operating, do not:
■ Crush, pull, damage or tread on the cable
that connects to the electrical mains.
Only disconnect the cable from the
■
electrical mains by removing the plug (do
not pull the cable).
■ Only replace the electric power cable
with one of the same type as the original:
H07 RN - F (EU); SJT (US). The same rule
applies if an extension is used.
■ The cable must be replaced
by the manufacturer's Service
Centre staff or by equivalent
qualified personnel.
www.blastrac.ca ‒ custserv@blastrac.com
6/17
WARNING!
WARNING!