Vacuum Cleaner Description; Vacuum Cleaner Parts And Labels - Blastrac BDC122 Manuel D'instructions

Operating manual BDC-122 / BDC-122H

Vacuum cleaner description

Vacuum Cleaner Parts and Labels

Figure 1
1. Identification plate which includes:
Model Code, which includes Class (H), Technical
Specifications (see table on page 6), Serial N°.,
EC Mark, Year of manufacture, Input voltage.
2. Longopac bag for collecting vacuumed material.
®
3. Inlet
4. Inlet plug.
5. Air outlet.
6. Castor locking lever.
7. Handle.
8. Closing band lever.
9. Safety bolt.
10. Filtration class label.
11. Warning plate.
Draws the operator's attention to the fact that
the filter must only be shaken when the vacuum
cleaner is turned OFF (see also par. "Primary filter
shaker").
12. Plug for connecting the vacuum cleaner to an
electrical socket.
This vacuum cleaner creates a strong air flow which is
drawn in through the inlet (3, Fig. 1) and blown out
through the outlet (5, Fig. 1).
Before turning on the vacuum cleaner, fit the vacuum
hose into the inlet and then fit the required tool on to
the end part (refer to the manufacturer's accessory
catalogue or Service Centre).
The diameters of the authorized hoses are indicated in
the Technical data table.
The vacuum cleaner is equipped with a main filter
which enables it to be used for the majority of
applications.
Besides the primary filter, which retains the most
common types of dust, the vacuum cleaner is fitted
with a secondary filter (absolute class H) with a
higher filtering capacity for fine dusts and dusts that
are hazardous to health.
1. Class H label
The class H label reads the following.
This vacuum cleaner contains dust
hazardous for the health.
Only authorised personnel wearing
suitable personal protective
equipment should empty and service the
vacuum cleaner, including removing the
means used to vacuum the dust. Do not use
without the complete filter system in place.
www.blastrac.ca ‒ custserv@blastrac.com
5/17
Figure 2
WARNING!
GB