Festo MPA Série Guide Rapide page 17

1 User
Valve terminal type VMPA−ASI−EPL−...−8E8A−Z has been
designed exclusively for controlling pneumatic actuators
and is only suitable for use in bus systems in accordance
with the AS−Interface specifications. If additional commer
cially−available components are connected, the specified
limits for pressures, temperatures, electrical data, torques,
etc. must not be exceeded.
The valve terminal enables the control of 8 valve solenoid
coils and the registering of 8 sensors. The exchangeable
connections of the CPX system are used for connecting the
sensors.
AS−Interface bus systems and valve terminals may only be
installed by personnel especially trained for this purpose.
Specifications on the design and addressing of your bus
system can be found in the manual for the AS−Interface
master.
Detailed information on the pneumatic components of the
valve terminal can be found in the Pneumatics manual type
P.BE−MPA−...
Warning
S Switch off the power supply before connecting or
disconnecting plugs (otherwise this could lead to
functional damage).
S Commission only a valve terminal which has been
fitted and wired completely.
Festo VMPA−ASI−EPL−...−8E8A−Z 0705NH English
instructionsEnglish
17