Altering The Position Of End Switches; Adjustment Of End Switch " Open - Bauer Jupiter 250 Mode D'emploi

Legend:
Feststellschraube :
Schraubendreher :
Endschalter:

17.2 Altering the position of end switches:

Using the screw driver included in the delivery you can remove the end switch ca-
bles from the guiding profile. After having released the locking screw of the end
switch, you can alter its position by moving or pulling the cable of the end switch.
When the end switch has reached the correct position, you have to fix it again using
the locking screw. The remaining cable of the end switch is introduced into the
crankcase.
cable of the end switch
screw driver

17.3 Adjustment of end switch " OPEN "

Unlock the operator using the emergency release (see page 20, point 18 " emergency
release " ) and move the gate until it reaches the desired position " OPEN " . Now ex-
change the connecting wires at the 3V button cell so that the LED of the end switch
" OPEN" will start to flash. Release the locking screw of the end switch " OPEN"
and move it towards " the end of the driving rod " until the LED of the end switch
" OPEN" ceases to flash. Now the end switch " OPEN" has reached the correct posi-
tion.
locking screw
screw driver
end switch
end switch
19