Installation (Indoor/Outdoor) - FLIR Lorex LZV2622 Série Manuel D'utilisation

4
Installation
1. Connect the BNC video connector on the camera cable to a single BNC
extension
cable up to 800ft / 242m long (not included).
2. Connect the female 12V DC power connector on the camera cable to the
included power adapter. Connect the power adapter to a power outlet.
•
3. Connect the BNC extension cable to one of the Video Input ports on the
DVR. Make note of the port number where you connect the camera, as it
will be used when
configuring the DVR to communicate with the camera.

4.3 Installation (Indoor/Outdoor)

The camera includes all necessary components for ceiling mounting and wall
mounting. For full instructions on each type of mounting, see 4.3.1 Wall
Mounting or 4.3.2 Ceiling Mounting.
Before installing the camera, decide whether to run the cables through the
wall / ceiling (drilling required) or along the wall / ceiling. If you run the cables
along the wall / ceiling, you must run the cable through the cable notch on the
dome camera base. This will keep the dome camera base flush to the ceiling
when mounted.
#LX400075; r.38010/38010; en-US
CAUTION
Make sure to disconnect the power adapter before installing the camera. The cam-
era will begin moving immediately when the power adapter is connected.
8