Installation; Installation Tips And Warnings; Extension Cables - FLIR Lorex LZV2622 Série Manuel D'utilisation

4

Installation

4.1 Installation Tips and Warnings

• Camera is rated for outdoor use. It is recommended to install the camera in
a sheltered area, such as under the eaves on a roof.
• Use the included wall mounting bracket for wall installation.
Otherwise, the camera image will be sideways. You can also refer to the
included
installation diagram guide for wall mounting instructions.
• Camera is capable of seeing in low light conditions (0.1 Lux), but it cannot
see in total darkness.
It is recommended to install the camera where there is some ambient light (for exam-
ple, street lighting or starlight, moonlight, etc.) or leave some lighting on in the area
where the camera is installed.
• Mount the camera in a location that can support the camera weight.
• Mount the camera where the lens is away from direct and intense sunlight.
• Plan your cable wiring so that it does not interfere with power lines or tele-
phone lines.
• Ensure you adhere to local building codes.
• Ensure that the camera wiring is not exposed or easily cut.
• Mount the camera in an area that is visible but out of reach.
This camera is suitable for ceiling mounting. Wall mounting requires included wall mount.

4.2 Extension Cables

• The included extension cable is 60ft (18.2m) long. If you are planning on
extending the camera's video cabling beyond 60ft (18.2m), see 4.2.2 Con-
nection Diagram for Extending the Cables Beyond 60ft (18.2m).
• Because this is a high-powered PTZ camera, the power cable cannot be
extended beyond 60ft (18.2m). You may connect the included power
adapter directly to the camera's power connector and plug the adapter into
a power outlet near the camera.
• The RS-485 wires on the camera cable are for service purposes only.
• You can extend the camera's video with a single cable run of up to 800ft /
242m long (not included). Video quality may decrease if your extension
#LX400075; r.38010/38010; en-US
NOTE
NOTE
5