General Safety Warnings - Bosch TDA 46 sensixx B3 Série Notice D'utilisation

Thank you for buying the TDA46
steam iron from Bosch.
This iron has been designed accor-
ding to ecological criteria, related
to the sustainable development;
analyzing its whole lifecycle, from
material selection to its later reusing
or recycling; evaluating the improve-
ment possibilities, from a technical,
economical and environmental point
of view.
This appliance has been designed
exclusively for domestic use and
must not be used for industrial
purposes.
Carefully read through the operating
instructions for the appliance and
safeguard them for future reference.

General safety warnings

Danger of electric shocks or
fire!
This appliance is to be connected
to the mains supply and used in
accordance with the information stated
on its specifications plate.
Never plug the appliance into the
mains supply if the cable or the
appliance itself shows visible signs of
damage.
This appliance must be connected to
an earthed socket. If it is absolutely
necessary to use an extension cable,
make sure that it is suitable for 16A or
more and has a socket with a earth
connection.
In order to avoid that, under unfavo-
urable mains conditions, phenomena
like transient voltage drops or lighting
fluctuations can happen, it is recom-
mended that the iron is connected to a
power supply system with a maximum
impedance of 0.27 Ω. If necessary, the
user can ask the public power supply
company for the system impedance at
the interface point.
This appliance is not intended to be
used by persons (including children)
with reduced physical, sensory or
mental capacities, or lack of experien-
ce and knowledge, unless they have
been given supervision or instruction.
Children should be supervised to
ensure that they do not play with the
appliance.
The appliance must be used and
placed on a stable surface.
When placed in the upright position
or in a support, make sure that the
surface on which the support stands
is stable.
The iron should not be used if it has
been dropped, if there are visible signs
of damage or if it is leaking water. In
these cases, it must be checked by an
authorized Technical Service Centre
before it can be used again.
Remove the plug form the socket
before filling the appliance with water
or before pouring out the remaining
water after use.
Never immerse the iron in water or
any other fluid.
The appliance must never be placed
under the tap to fill the water.
Do not leave the appliance exposed
to weather conditions (rain, sun, frost,
etc.)
The electrical plug must not be
removed from the socket by pulling
the cable.
Unplug the appliance from the mains
supply after each use, or if a fault is
found.
With the aim of avoiding dangerous
situations, any work or repair that the
appliance may need, e.g. replacing
a faulty mains cable, must only be
carried out by qualified personnel
from an Authorised Technical Service
Centre.
Unplug the iron from the mains supply
when you have to leave the iron
unattended.
en
9