Ironing With Steam - Bosch TDA 46 sensixx B3 Série Notice D'utilisation

Ironing with steam

1. Turn the temperature selector to the
required setting.
2. Set the amount of steam to suit your
needs, using the variable steam
control.
For normal use, please choose one of
the following recommended settings:
Recomended Steam
Temperature
Regulator
•••
"max"
••
Spray
Do not use the Spray function with
silk.
Shot of Steam
Set the temperature control dial to at
least the "•••" position
Interval between shots of steam
should be 5 seconds.
Vertical Steam
Do not iron clothing while it is being
worn!
Never direct the steam at persons
or animals!
Interval between shots should be 5
seconds.
Wait 10 seconds after each 4 shot
cycle.
Multiple descaling system (7)
Depending on the model, this range
is equipped with
(=component 1 + 2 + 3).
1. self-clean
Each time you use the steam regulator,
the "self-clean" system cleans the
mechanism of scale deposits.
2. calc'n clean
The "calc'n clean" function helps to
remove scale particles out of the
steam chamber. Use this function
(3)
approximately every 2 weeks, if the
water in your area is very hard.
Fill the water tank, set the temperature
control dial to the "max". position and
plug in the iron.
After the necessary warm-up period,
unplug the iron and hold it over a sink.
Position the steam regulator to the
"calc'n clean" position and keep it in
this position. Gently shake the iron.
Boiling water and steam will come out,
carrying scale or deposits that might
be there. When the iron stops dripping,
calc'n clean
position the steam regulator to the
position. For improved de-scaling,
calc'n clean
heat up the iron again fully and press
(4)
the steam button several times in
quick succession. Then wait until the
remaining water has evaporated from
the soleplate of the iron.
3. anti-calc
(5)
The "anti-calc" cartridge has been
designed to reduce the build-up of
scale produced during steam ironing,
helping to extend the useful life of
your iron. Nevertheless the "anti-calc"
cartridge cannot remove all of the
(6)
scale that is produced naturally over
time.
"Secure" auto shut-off
function
(Depending on model)
The "Secure" auto shut-off function
switches off the iron when it is left
unattended, thus increasing security
and saving energy. After plugging
in the appliance, this function will be
inactive for the first two minutes in
order to give the appliance time to
the "AntiCalc"
reach the set temperature.
Alter such time, if the iron is not moved
for 8 minutes while in the upright
position or 30 seconds while resting
on its soleplate or on its side, then the
safety circuit will switch the appliance
off automatically and the pilot light will
start flashing.
To reconnect the iron, just move it
about gently.
en
(8)
11