Cleaning The Dust Bin - LG VR6260 Série Guide D'utilisation

If the dust bin is full, suction power can be reduced. Clean the dust bin before and after each cleaning session. Clean the dust bin
using the following sequence:
1. Open the dust bin cover by pressing the PUSH button on the
Robot Cleaner.
2. Grab the handle of the dust bin and pull it upward.
3. Pull the hook on the left of Filter Cover on the rear of Dust
Bin to separate the fi lter and the sponge.
※ Note that separating the fi lter may result in dust dropping.
※ Refer to p.30 when cleaning the Dust Bin Filter.
4. Lift the cover upward while pressing the separation button
on the dust bin.
5. Empty the dust bin and clean it with a cleaning brush or
under running water.
6. After cleaning with water, completely dry the dust bin in a
well-ventilated area out of the direct sunlight.
7. When reassembling or fi tting the cleaned Dust Bin, close the
cover and put in the Sponge and HEPA Filter.
※ Refer to p.30 for detailed assembly guides.
8. Put the dust bin into the Robot Cleaner and close the dust
bin cover.
Tip
• Operating the unit without Filters fitted to the dust bin can cause a motor malfunction not covered by warranty.
• After cleaning the Dust Bin, make sure to assemble the filter and fit it to the Dust Bin.
If you initiate cleaning, with no filters fitted to the dust bin or Filter Cover not assembled,
a voice message will be announced which says "Please check that the dust bin and filter are properly installed."
• Always ensure that the dust bin cover is refitted correctly after cleaning the
dust bin so that it closes easily and accurately.

CLEANING THE DUST BIN

29