Samsung POWERbot SR1AM7040W Série Guide D'utilisation page 13

Automatic charging
Recharging
Low battery (Lo)
Steps to take if automatic recharging is not occuring:
Reconsider the location of the docking
station when:
fthe docking station is located in a place where
the POWERbot cannot easily access it.
fthe distance between the docking station and
POWERbot is over 16.4 ft (5 m).
– It may take a long time for the POWERbot to
return to the docking station for recharging
1. SR1AM7010UW Series
If the battery indicator blinks at 0.4 sec. intervals,
the POWERbot will automatically return to the
docking station to recharge.
2. SR1AM7040W✴ / SR2AM70✴✴✴✴ Series
When the battery indicator blinks during cleaning,
the POWERbot will return to the docking station to
charge itself automatically.
You can command the POWERbot to
recharge at the docking station while it is
cleaning.
You can manually charge the POWERbot by
placing it in the docking station.
Manually charge the POWERbot when:
fthe docking station is located in a corner
fthe battery is fully exhausted
fthe POWERbot is immobilized by an obstacle
(furniture, etc.)
fthe POWERbot can't climb a threshold near
the docking station (The maximum height of
a threshold the POWERbot can climb is about
0.6 in (1.5 cm)).
fthe battery indicator blinks and "Lo" is
displayed
fthe battery indicator blinks (Applicable to
SR1AM7010UW Series)
fthe POWERbot is set to the Spot clean or
Manual clean mode
ENGLISH-13