Illinois Tool Works Stero SU-L Mode D'emploi Et D'installation page 9

INSTALLATION
3. A hole for 1" trade size conduit is supplied at the lower right in the back of the machine (Figure 3). If
necessary due to space requirements, remove the knockout and use a 45° fitting.
4. Install 1" trade size conduit and fitting. Leave at least four feet of electrical line between wall connection
and machine. This allows machine to be pulled away from the wall for cleaning and/or servicing.
5. Feed wires thru base of unit to front of unit. At least 24" and not more than 28" of the required wire
size must extend from the end of the conduit fitting.
6. Make electrical connections according to wiring diagram supplied with the machine and secure wires
to the machine service connection. Keep excess wire in the base of the unit to a minimum.
7. Replace the left side panel, top of unit, and lower front panel. Re-install the three screws located behind
the door and the two screws at the bottom of the front panel.
STERO UNDERCOUNTER DISHWASHER & GLASSWASHER
(continued)
KNOCKOUT
Figure 3
| 9