Operating The Stero Dishwasher & Glasswasher - Illinois Tool Works Stero SU-L Mode D'emploi Et D'installation

OPERATION
OPERATING THE STERO DISHWASHER & GLASSWASHER
Do This
Press ON.
Open door; slide rack of dishes
into dishwasher. Close door.
Press WASH.
When cycle is complete, reload
machine for next wash/rinse
cycle; or, if not in use, machine
will maintain idle mode.
At the end of the day, press
POWER.
(continued)
Display Shows
Model number.
FILL and fill icon lit; sump temperature
displayed when machine is filling.
WARMING UP and warming up icon
are displayed when booster is pre-
heating. This preheat could take up to
15 minutes.
During fill, sump temperature is
displayed.
READY lit and sump temperature
displayed.
WASH and wash icon lit; sump tem-
perature displayed during wash cycle.
RINSE and rinse icon lit; rinse tem-
perature displayed during rinse cycle.
READY lit and sump temperature
displayed.
DRAIN and SHUTDOWN IN PROGRESS
are displayed; then the display shuts
down.
STERO UNDERCOUNTER DISHWASHER & GLASSWASHER
Remarks
Dishwasher performs self-check. This
takes 5 seconds.
Dishwasher fills with water. When
filled, pump turns on for 10 seconds.
If door is opened during fill cycle, fill
will stop. After door is closed, the pro-
cess continues where it stopped.
When filled, machine will maintain an
idle state. Heat is maintained in both
sump and/or booster.
Detergent will be added automatically
during wash cycle.
Rinse Aid and Sanitizer will be added
automatically during rinse cycle.
(NOTE: Sanitizer only used on SU-L &
SG models.)
Machine initiates a wash and rinse
cycle.
If door is opened during wash, rinse,
or drain cycle, cycle will continue at
point where door was opened upon
closing door.
If POWER is pressed during cycle,
machine will drain and shut down.
Machine will drain and shut down if
the four hour idle shutdown time is
reached.
When POWER key is pressed, machine
will drain and shut down.
| 17