Detergent And Rinse Aid; Chemical Sanitizer (Su-L & Sg Models) - Illinois Tool Works Stero SU-L Mode D'emploi Et D'installation

10 |
STERO UNDERCOUNTER DISHWASHER & GLASSWASHER
INSTALLATION
(continued)

DETERGENT AND RINSE AID

Use only commercial-grade detergents recommended by your chemical professional. Do not use detergents
formulated for residential dishwashers.
SU UNDERCOUNTER ONLY:
The detergent and rinse aid pump "ON" times are factory-set. If adjustments are required, contact your local
service provider or your chemical supplier.
Place the detergent and rinse aid containers (which are obtained from an independent supplier) in a location
where the delivery tubes will reach them.
Remove the detergent bottle cap and put the red delivery tube in the detergent container.
Remove the rinse aid bottle cap and place the blue delivery tube in the rinse aid container.
Be sure to push the delivery tube standpipes completely to the bottom of each container. Check to make sure
there are no obstructions or kinks in the delivery tubes.
SG GLASSWASHER ONLY:
Place the detergent and rinse aid containers (which are obtained from an independent supplier) under the
glasswasher (or nearby for shorter version).
Remove the detergent bottle cap and put the red delivery tube in the detergent container by snapping the
bottle connector onto the container.
Remove the rinse aid bottle cap and place the blue delivery tube in the rinse aid container by snapping the
bottle connector onto the container.
Be sure to push the delivery tubes completely to the bottom of each container. Check to make sure there are
no obstructions or kinks in the delivery tubes.
CHEMICAL SANITIZER
Items such as pewter, aluminum and silver will be attacked by sodium hypochlorite (bleach).
Therefore, chemical-sanitizing dishwashers should not be used to wash such items.
The chemical sanitizer pump is factory-set for use with 6% sodium hypochlorite solution.
On SU-L & SG models, place a 1-gallon bottle of 6% or 8.40% sodium hypochlorite solution (bleach) in a suit-
able location no higher than 10 inches off the floor. Do not pre-mix sanitizing solution with water or any other
liquid.
Never premix a wetting agent with the sanitizing solution. Mixing may cause
hazardous gas to form.
Remove the sanitizer bottle cap and place the white delivery tube in the sanitizer container. Be sure to push
the delivery tube standpipe completely to the bottom of the container. Check to make sure there are no
obstructions or kinks in the delivery tube.
Frequently check your sanitizer bottle to make sure there is a sufficient chemical supply.