Connecting The Power Cord - Insignia NS-CL01 Guide De L'utilisateur

Insignia NS-CL01 Clock Radio with iPod® Dock
3 Place the backup battery cover back on the compartment, then
rotate it clockwise until it locks.

Connecting the power cord

To prepare your clock radio for use:
1 Make sure that your local AC power source matches the voltage
shown on the plate located on the AC power adapter. If it does not,
consult your dealer or service center.
2 Plug the small connector on the power cable into the DC IN jack
on the back of the clock radio and the AC power adapter itself into
an AC power outlet.
3 Press the
To completely turn off the clock radio, unplug the AC power
adapter from the AC power outlet.
Caution
Caution
Follow these precautions when using batteries in this
device:
1. Use only the size and type of batteries specified.
2. Make sure that you follow the correct polarity as indicated
in the battery compartment when installing batteries.
Reversed batteries may cause damage to the radio.
3. Do not mix different types of batteries together (for
example, alkaline, rechargeable, and carbon zinc), or
semi-used batteries with fresh ones.
4. If your clock radio is not to be used for a long period of
time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be
recharged, because they can overheat and rupture. (Follow
battery manufacturer's directions.)
6. Do not throw batteries into a fire. Dispose of used
batteries as hazardous waste.
Note
The backup battery is used to back up the clock and alarm
times only.
When the battery is depleted, it should be changed
immediately.
(Standby/on) button to turn on your clock radio.
To protect your clock radio during thunderstorms, unplug the
AC power adapter from the AC power outlet.
www.insignia-products.com 11