Maintenance; Front Glass Removal And Installation; Log, Grate And Ember Bed Assembly Removal - Napoleon Lambert NEFB27H Manuel D'installation Et D'opération

4.0 maintenance

EN
WARNING
!
• Power supply service must be completed prior to finishing to avoid reconstruction.
• Heat vents and air openings cannot be covered in any circumstances.
4.1

front glass removal and installation

WARNING
!
• Before door is removed, turn the appliance off and wait until it is cool to the touch. Doors are heavy and fragile
so handle with care.
Unplug the plug.
A.
Remove the 4 screws from the brackets securing the appliance to the media console (Fig. 4-1).
B.
Remove the appliance from the media console.
C.
Remove the 4 screws from both sides of the appliance (Fig. 4-2).
D.
Remove the glass front and place on a soft non-abrasive surface.
E.
Reverse these steps to reinstall the glass front.
F.
4.2

log, grate and ember bed assembly removal

Unplug the plug.
A.
Remove the 4 screws from the brackets securing the appliance to the media console (see Fig. 4-1 in
B.
"front glass removal and installation" section).
Remove the appliance from the media console.
C.
Remove the 4 screws securing the ember bed to the sides and bottom of the appliance (Fig. 4-3).
D.
Lift the log, grate, and ember bed up from the appliance and remove.
E.
Reverse these steps to reinstall the log, grate, and ember bed.
F.
Screw
Screw
16
W415-1981 / A / 07.20.20
Fig. 4-1
Bottom View
Fig. 4-3
SCREW
Fig. 4-2
Side View
Screw
Screw