Walter Surface Technologies ICECUT MINI 39-D 050 Instructions D'origine page 5

ICECUT MINI Low-Profile
TOOL USE AND CARE
1. Use clamps or other practical way to secure and support the workpiece to a stable platform. Holding the work
by hand or against your body is unstable and may lead to loss of control.
2. Do not force tool. Use the correct tool for your application. The correct tool will do the job better and safer at
the rate in which it is designed.
3. Do not use tool if switch does not turn it on or off. Any tool that cannot be controlled with the switch is
dangerous and must be repaired.
4. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing
the tool. Such preventive safety measures reduce the risk of starting the tool accidentally.
5. Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of
untrained users.
6. Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools, with sharp cutting
edges are less likely to bind and are easier to control.
7. Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect
the tools operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly
maintained tools.
8. Use only accessories that are recommended by the manufacturer for your model. Accessories that may be
suitable for one tool, may become hazardous when used on another tool.
9. Always use safety strap. Mounting can release.
SERVICE
1. Tools service must be performed only by qualified repair personnel. Service or maintenance performed by
unqualified personnel could result in a risk of injury.
2. When servicing a tool, use only identical replacement parts. Follow instructions in the Maintenance section of
this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of electric
shock or injury.
ADDITIONAL IMPORTANT SAFETY NOTES
1. Remove the power supply before carrying out any adjustment, servicing or maintenance.
2. Consider work area environment;

Do not expose tools to rain.

Do not use tools in damp or wet locations.

Keep work area well lit (500 Lux recommended).

Do not use tools in the presence of flammable liquids or gases.

Ensure there is adequate space to gain access to the plug, mains and motor on/off switches.
3. Guard against electric shock:

Avoid body contact with earthed or ground surfaces (e.g. pipes, radiators, cookers and refrigerators). Electric
safety can be further improved by using a high-sensitivity (30 m A/0.1s) residual current device (RCD).
4. Keep other persons away. Do not let untrained persons, especially children, touch the tool or the extension cord
and keep them away from the work area.
5. Store idle tools when not in use. All tools should be stored in a dry locked-up place, out of reach of children.
6. When using the drill, always ensure a safe operating distance from any swarf and do not reach into the cutting
area, or near the cutter, when the machine is running.
7. Connect dust extraction and collecting equipment, if devices are provided, ensuring these are properly connected
and used.
8. Do not overreach! Keep proper footing and balance at all times.
9. Maintain tools with care;

Keep cutting tools sharp and clean for better and safer performance.

Regularly check the machine for any wear or damage.

Ensure the machine is clean and free from debris prior to use.

Remove from the mains prior to any maintenance.

Follow instructions for lubricating and changing accessories.
Original Instructions
5
03-2019