Enerpac SQD-I Série Guide D'instructions page 5

9
A
B
C
D
E
F
4.0 ASSEMBLING THE WRENCH
9
See . All parts must be free of dirt and
greased according to Section 6.1. Follow the
steps below:
Slide the reaction arm (6) over the wrench
A
body (1) in the correct position. See also
3 5
and
the locking mechanism (3).
Push drive release (5) into the wrench (1)
B
and position the square drive (4).
Push the button in the drive release (5)
C
and push square drive (4) against (5).
Keep pushing (4) while pressing and
D
turning (5) so both parts click into the
locked position. Check this by pulling the
square drive.
Secure the socket (7) on square drive (4)
E
using a locking pin (8) and O-ring (9).
IMPORTANT: The Allen-key drive fits in
the same way in the drive release as the
square drive (4). When using the Allen-
key drive the reaction arm for Allen-key
drives (8) must be used.
Connect the Enerpac THC-700 series
F
3,5:1 safety twin hoses (10) to the swivel
hose connection (2).
WARNING: See
correct way to connect the hoses
between wrench and pump.
5.0 CONNECTING THE WRENCH TO THE
PUMP
Enerpac torque wrenches can be powered by
a range of electric or air-driven torque wrench
pumps. For complete operating instructions,
refer to the instruction sheet included with
each Enerpac pump.
IMPORTANT: It is mandatory that
the
understanding of all instructions,
safety regulations, cautions and warnings,
read.eps
before starting to operate any of this high force
tool equipment. To ensure correct pump and
wrench control it is recommended to use an
Enerpac torque wrench pump. When in doubt,
contact Enerpac.
5
. Secure the reaction arm with
10
on page 6 for the
operator has a full