Safety Instructions - Axis Q3517-SLVE Mode D'emploi

AXIS Q3517-SLVE Network Camera

Safety instructions

CAUTION
Be careful of sharp metal edges. Use cut-resistant gloves during installation.
NO TICE TICE
NO NO TICE
• The Axis product shall be used in compliance with local laws and regulations.
• Store the Axis product in a dry and ventilated environment.
• Do not install the product on unstable poles, brackets, surfaces or walls.
• Use only applicable tools when installing the Axis product. Using excessive force with
power tools could cause damage to the product.
• Use only accessories that comply with the technical specification of your product. These
can be provided by Axis or a third party. Axis recommends using Axis power source
equipment compatible with your product.
• Use only spare parts provided by or recommended by Axis.
• Do not attempt to repair the product yourself. Contact Axis support or your Axis reseller
for service matters.
Transportation
NO TICE TICE
NO NO TICE
• When transporting the Axis product, use the original packaging or equivalent to prevent
damage to the product.
Battery
The Axis product uses a 3.0 V CR2032 lithium battery as the power supply for its internal real-time
clock (RTC). Under normal conditions this battery will last for a minimum of five years.
CAUTION
Do not replace the battery yourself. Contact Axis support if the log message requests a
battery change.
Lithium coin cell 3.0 V batteries contain 1,2-dimethoxyethane; ethylene glycol dimethyl ether
(EGDME), CAS no. 110-71-4.
Dome cover
NO NO TICE NO TICE TICE
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
24