Reset To Factory Default Settings - Axis Q3517-SLVE Mode D'emploi

AXIS Q3517-SLVE Network Camera

Reset to factory default settings

Important
Reset to factory default should be used with caution. A reset to factory default resets all
settings, including the IP address, to the factory default values.
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button while reconnecting power. See Product overview
on page 8.
3. Keep the control button pressed for 15–30 seconds until the status LED indicator flashes
amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90.
5. Use the installation and management software tools to assign an IP address, set the
password, and access the video stream.
The installation and management software tools are available from the support pages
on axis.com/support.
It is also possible to reset parameters to factory default through the web interface. Go to Settings
> System > Maintenance and click Default.
16