Joyello KLACK JL-988 Mode D'emploi page 10

GB
USE FOR GROUP II - III
Only the car's 3-point safety belts must be used to secure the baby seat.
Adjusting the height of the headrest
Regularly check if the headrest is at a suitable height for your child. The height of the headrest is
correct and corresponds with the size of the baby when the child's head rests comfortably in the
middle.
• To adjust the height, pull the handle behind the headrest.
Secure the car seat with the vehicle's seat belt
The 3-point belt system of the vehicle may only be used to fasten children of Groups II and III (15
kg - 36 kg).
Step 1: Place the child seat on the vehicle's seat, making sure it is firmly pressed against the backrest
of the seat.
Step 2: Place your child on the seat.
Step 3: Unroll the 3-point safety belt and place the lap belt on the opposite side of the buckle under
the armrest (make sure that the diagonal belt and the lap belt on the side of the buckle are under
the armrest). The lap belt should be worn low so that the hips are secured and the straps are not
twisted. Insert it into the buckle until you hear a "click".
MAKE SURE THAT BOTH THE ABDOMINAL AND DIAGONAL BELT PASS THROUGH THE
APPROPRIATE HOUSINGS INDICATED BY THE ARROW
10