Getting Started; Time Settings - Audizio 102.216 Guide De Démarrage Rapide

QUICK START GUIDE

GETTING STARTED

1. Unpack the digital radio and remove all packing materials.
2.Completely unwind the power cord and plug it into the wall outlet.
3. Pull out the antenna completely.
USAGE
1. Press the [POWER]-button on the remote control or directly on the radio to turn on the unit.
2. Turn the [VOLUME]-knob on the radio or use the remote control volume buttons for the desired sound level.
Note:
1. If the digital radio is not used for 15 minutes, it will automatically enter into standby mode.
2. AUX mode is used for more than 4 hours, the unit will switch to standby mode.
15 minutes before entering standby mode. you will be notified with "AUTO-OFF" flashing on the display. To extend the AUX
mode you can press RANDOM button."

TIME SETTINGS

Manual time setting
1. In standby mode, press the [TIMER/CLOCK]-button on the remote control.
2. Set the hour with the [ ] or [ ]-button. Press the [TIMER/CLOCK] button to confirm the hour.
3. Set the minutes using the [ ] or [ ]-button. Press the [TIMER/CLOCK] button to confirm.
Note: Set the time manually if you are not receiving DAB+ signal. As soon as the radio receives DAB+ signal, the time will be
set automatically.
DAB+-MODUS
When the radio is connected to the power supply for the first time, the DAB+ mode will be switched on automatically. The
radio will automatically scan for suitable stations.
When station search is complete, you can use the [ ] or [ ]-button to tune in the individual stations. The stations are
displayed alphabetically. To select a station, press the [ENTER] key.
Full Scan
The "Full Scan" searches all DAB+ and Band III channels. After searching for a channel, the found channels are listed
alphabetically and the first channel is played back.
1. To activate the scan, press the [SCAN] button until the display shows
2. All found stations are automatically saved. Use the [ ] or [ ]-button to find the desired station and press the [ENTER]
button on the remote control to select the station.
FM MODE
Switch from DAB+ mode to FM mode by pressing the function button and selecting FM or by pressing the DAB/FM button on
the remote control. The display will show the frequency.
Automatic station search
Press the [SCAN] button on the remote control or [PLAY/PAUSE] button on the radio to start the automatic station search.
When a station is found, the scan stops automatically.
Manual station search
Press the [PREV/NEXT] buttons to manually select a station.
BT-Modus
You can connect a mobile device to your radio via BT. Switch to BT mode by pressing the [FUNCTION] button and selecting BT
or pressing the BT/AUX button on the remote control.
1. Turn on the BT function of your mobile device and search for the BT's Audizio Prato name.
2. If a password is required, enter the "0000".
3. Play the desired audio file from your mobile device. It will be sent to your radio automatically and will sound over the
speakers.
4. To disconnect the connection between your mobile device and your radio, turn off the BT function on your mobile device
or change the mode of your radio by pressing the [FUNCTION] button.
Note: If the signal is weak, make sure there is no interference between your mobile device and the radio.
Some mobile devices may disconnect on incoming calls.