Kibernetik Nanyo 25AA Manuel D'utilisation page 39

4. When the unit is switched off the most recent setting will be stored in memory.
5. The timer function allows you to switch the unit on or off at a certain time:
1. Press TIMER button to set the operating hours you desired (1 to 12 hours, the
timer indicator will light on). When the set time has been reached, the machine
will turn off automatically. The display window will show the hour(s) you set as
you press TIMER button. If the timer button is not pressed, the unit will work
continuously.
2. By pressing the timer but without turning on the other functions, you can PRE-
SET the time for the machine to work. For example, if you press the timer to '2',
the unit will work automatically after 2 hours.
Note!
The compressor has been set so that it starts functioning three minutes after the (re)start
of the air conditioner. The cooling will switch off when the room temperature is lower than
the set temperature. Air circulation will however continue to work on the set level. When
the room temperature rises above the set temperature, the cooling will work again.
Sleep Mode
By pressing the Sleep button, the set temperature will increase 1ºC at the first hour,
another 1ºC at the second hour. The unit will then keep its temperature. The ventilation will
remain at low speed. After pressing the sleep button again, the set temperature and
ventilation speed will return to the pre-selected one.
Note!
This function is not available in the Auto or Fan mode.
Remote Control
A. Power on / off button
B. Temperature + / - buttons
C. Fan Speed button
D. Timer button
E. Function button
F. Sleep button
The remote control works in combination with the control panel. Aim the
front end of the remote control at the control panel. The maximum
operating distance from the air conditioner is approximately 5 metres.
Place 2 pieces of AAA Batteries before use.
OPERATING MANUAL | Air Conditioner Nanyo 25AA
39