Kibernetik Nanyo 25AA Manuel D'utilisation page 38

OPERATING MANUAL | Air Conditioner Nanyo 25AA
1. Insert the plug into the wall outlet.
2. Press the
automatic mode :

If the ambient temperature is higher than 23°C, the unit will work in cooling
mode.

If the ambient temperature is < 23°C, the unit will work in air circulation mode..
3. With the
-button the following modes appear:
Automatic mode
Cooling mode
Air circulation mode
Cooling
When the unit is in the cooling mode, the following functions apply:

The fan speed can be adjusted by pressing the
Maximum setting
Lowest setting
The temperature can be set by pressing the
en 32°C. The display will show the set temperature for 8 seconds and the "set temp" will
light up. Fifteen seconds after setting the required temperature, the display will show the
room temperature. The pre-set temperature for this unit is 24ºC for cooling.
It depends on the environment whether the required temperature will be reached. It is not a
malfunction of the air conditioner if the room temperature remains above the "set temp". It
could well be that the heat load of the room is too much.
Air Circulation
In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air is filtered. When the unit is in this mode, the following functions apply:

The fan speed can be adjusted by pressing the
Maximum setting
Lowest setting
In auto mode, the unit will choose the ventilation speed automatically according to the
ambient temperature. The speed switch cannot be changed in this mode.
38
-button, to switch on the air conditioner. The air conditioner starts in the
-button you can change the operating mode of the unit. By pressing the
-button:
and buttons, anywhere between 18°C
-button: