Kenwood DDX7015 Manuel D'installation page 4

Connection
2WARNING
If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may start a fire. Always connect those wires to the
power source running through the fuse box.
Ground wire (Black) - (To car chassis)
C
Battery wire
(Yellow)
B
Ignition key
switch
Car fuse
box
(Main fuse)
+
–
+
Battery
4 English
Connect to the vehicle's parking brake detection switch harness
using the supplied relay connector.
2CAUTION
For the sake of safety, be sure to connect the parking sensor.
PRK SW Parking sensor wire (Green)
( 5A )
ACC
A
B
Car fuse box
C
B
To car light control switch
A
C
Depending on what antenna you are using,
connect either to the control terminal of the motor
antenna, or to the power terminal for the booster
amplifier of the film-type antenna.
When using the optional power amplifier, connect
to its power control terminal.
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
FM/AM antenna input
Battery wire (Yellow)
Dimmer control wire (Orange/White)
Ignition wire (Red)
Ground wire (Black) - (To car chassis)
Motor antenna control wire
(Blue)
Power control wire
(Blue/White)
External amplifier control wire
(Pink/Black)