Attach The Belt - Axonics SNM System 1401 Manuel D'utilisation

Press the green ring of the Belt onto the bottom of the Charger.
1
Start by pressing with both fingers at the bottom of the inner
circle of the ring. Slide your fingers in opposite directions to the
top of the ring.
The Charger is ready to be put on your body.
2
Note: The Charger should be placed on the side of the Belt where green
stitching is visible around the green ring.
Note: If using the carrier, attach the ring of the carrier to the Charger just as
you would the belt. The adhesive pads on the carrier should face away from
the Charger. Peel back the protective liner to expose the adhesive.

2) Attach the Belt

21