Initial Operation - Clatronic HL 2994 Mode D'emploi & Garantie

• The fan heater must not be operated directly under a mains power socket.
• Allow the unit to cool down before you put it away.
• Do not put any objects into the unit.
• Warning!
Do not cover the device or place any objects on it.
Danger of overheating!
• Do not use this heater in the direct vicinity of a bath, shower or swimming pool.
Never operate the heater when you are in any of the above. Keep a safety
distance of 1,25 metres.
• In order to ensure your children's safety, please keep all packaging (plastic
bags, boxes, polystyrene etc.) out of their reach.
• Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
• Make sure that the degree of protection of the socket to which the device is
connected is of at least 10 ampere!
• Place the device on any heat-resistant fl at surface. Ensure that air can enter
and leave unhindered.
• The distance from the air inlet grille to the nearest wall should be at least 20
cm. The distance from the air outlet grille to the nearest wall should be at least
1 m.
The indicator light lights up when the unit is in operation.
After use, pull the plug out of the socket.
Function Switch
O = OFF
I = Hot air (1000 W)
Thermostat
You can set the room temperature with the temperature control.
Lowest level

Initial Operation

II = Hot air (2000 W)
= Cold air
Highest level
GB
37