Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Problem
Pressure incorrect
Dirt within the mechanism
Air blockage
Tool operating slowly
Air leak
Blockage in gauze mesh filter
Dirt or rust in mechanism
Tool seized
Dirt or rust in mechanism
Dirt or rust in mechanism
Cutting disc fitted incorrectly
Cutting disc damaged (cracks,
Strong vibrations when tool
deformations or splinters)
is switched on
Flange damaged (burred or notched) Replace flange
Spindle bent
Throttle valve O-ring or valve seat
Tool will not stop after
damaged
trigger is fully released
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service
centre.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
Possible Cause
Solution
Set the correct air pressure according to the specification
Pour oil into air inlet as per maintenance instructions
Operate tool in short bursts to clear blockage
Check all fittings and hose for air leaks and correct issue by re-
tightening, using PTFE tape or replacing
Remove Quick Connector (10) and clean mesh filter
Try 'Tool operating slowly' solutions
Tap tool gently with a soft mallet
Free mechanism by rotating drive manually when disconnected
from air line
Remove disc, inspect for damage and refit
Replace cutting disc
Have the tool repaired by an authorised Silverline service centre
Have the tool repaired at an authorised Silverline service centre
T: 00352/26908036 – F: 00352/26908040
SPT-15103
SPT-15105
Publicité
Table des Matières
