General Safety Warnings; Projectile Hazards; Entanglement Hazards; Operating Hazards - Varan SPT-15103 Manuel D'utilisation

General Safety Warnings

• For multiple hazards, read and understand the safety instructions before installing, operating,
repairing, maintaining, changing accessories on, or working near this tool. Failure to do so can
result in serious bodily injury
• Only qualified and trained operators should install, adjust, or use this tool
• Do not modify this tool. Modifications can reduce the effectiveness of safety measures and
increase the risks to the operator
• Do not discard the safety instructions; give them to the operator
• Do not use this tool if it has been damaged
• Tools shall be inspected periodically to verify that the ratings and markings required by this part
of ISO 11148 are legibly marked on the tool. The employer/user should contact the
manufacturer to obtain replacement marking labels when necessary
• WARNING: This appliance is not intended for use by persons (including children) with reduced,
physical or mental capabilities or lack of experience or knowledge unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety. Children must be supervised to ensure that they do not play with the appliance.

Projectile Hazards

• Be aware that failure of the workpiece or accessories, or even of the inserted tool itself, can
generate high-velocity projectiles
• Always wear impact-resistant eye protection during operation of this tool. The grade of
protection required should be assessed for each use
• For overhead work, wear a safety helmet
• The risks to others should also be assessed at this time
• Ensure that the workpiece is securely fixed

Entanglement Hazards

• Choking, scalping and/or lacerations can occur if loose clothing, personal jewellery, neck wear,
hair or gloves are not kept away from the tool and its accessories

Operating Hazards

• Use of the tool can expose the operator's hands to hazards, including cuts, abrasions and heat
• Wear suitable gloves to protect hands
• Operators and maintenance personnel should be physically able to handle the bulk, weight and
power of the tool
• Hold the tool correctly; be ready to counteract normal or sudden movements and have both
hands available
• Maintain a balanced body position and secure footing
• Release the start-and-stop device in the case of an interruption of the energy supply
• Use only lubricants recommended by the manufacturer
• Personal protective safety glasses should be used; suitable gloves and protective clothing are
recommended
• Inspect the cutting disc before each use. Do not use if cracked or broken or if it has been
dropped
• Avoid direct contact with moving parts in order to prevent pinching or cutting of hands or other
body parts.
• Wear suitable gloves to protect hands
• Never switch the tool on or off while the disc is in contact with the workpiece
• There is a risk of electrostatic discharge if used on plastic and other non-conductive materials
• Potentially explosive atmospheres can be caused by dust and fumes resulting from cutting or
grinding
• Always use dust extraction or suppression systems which are suitable for the material being
processed
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040
SPT-15103
SPT-15105