Air Naturel Desair Mode D'emploi page 9

BEFORE USING DESAIR
Before plugging the device on mains
power, check that the Desair is turned off.
• Place the dehumidifier on the floor. Plug the
power cord to the mains power and turn
the device on. Desair is ready to use!
• Push on the POWER button.
• After a few seconds, Desair shows relative
humidity (hygrometry), visible on panel
control.
• Let the device working until you get the
wanted humidity rate.
• Red light means water tank is full.
• The device automatically stops when water
tank is full.
• Unplug the device.
• Take off the water tank and drain it.
• Replace water tank on its basis.
• Plug the device.
• Desair is ready to work again.
PANEL CONTROL
Power
Push once the power button to turn the device
on. Then the pictogram turns blue.
power button another time to turn it off. It will
stops after few seconds.
Timer
The timer function is made to program
automatic shutdown. + 01 hour is added every
time you press the button. While Timer function
is ON, its LED turns blue. To turn off the timer
function, press the button to reach 24h00 and
come back to 0. LED turns off. Press this button
for 5 seconds, the LED display can show the
room temperature(°c).
dehumidify indicator
When the device is working, its light turns on
and shows blue. When the device is off, its light
switches off.
Led display
When the device is ON, the led display shows
the hygrometry rate (%). The hygrometer has
an error rate, about ± 5%. The Led display can
always show room temperature (°C) while
pressing timer button for 5 seconds.
Ionization
While the device is working, the ionization
option turns on. Its LED turns green.
Push the
Water tank
Water tank led turns red when the tank is full or
if it is not well placed on the device. You should
drain it or replace it regarding the problem.
9