Display Menu; Master/Slave Mode; Sound Sensitivity - Ibiza Light MHSPOT30-FX Manuel D'utilisation

MANUAL - MHSPOT30-FX
3. DMX SET UP
Notice: Be sure to follow figures two and three when making your own cables. Do not use the ground lug on the XLR
connector. Do not connect the cable's shield conductor to the ground lug or allow the shield conductor to come in
contact with the XLR's outer casing. Grounding the shield could cause a short circuit and erratic behavior.
Special Note: Line Termination. When longer cable
runs are used, you may need to use a terminator on
the last unit to avoid erratic behavior. A terminator
is a 110-120 ohm 1/4W resistor which is connected
between pins 2 and 3 of a male XLR connector (DATA
+ and DATA -). This unit is inserted in the female XLR
connector of the last unit in your daisy chain to termi-
nate the line. Using a cable terminator will decrease the
possibilities of erratic behavior.
4.

DISPLAY MENU:

Setting of the DMX address: Press MENU to select Addr, press Enter to start setting. Use
the UP or DOWN keys to set the desired Address. Then press Enter to confirm.
Selection of the channel mode: Press MENU to select Chnd. Press Enter to start setting
Select the channel mode via the UP or DOWN keys: successively 9CH and 11CH. Press Enter
again to confirm your selection.
9CH: 9Channel mode
11CH: 11Channel mode
Setting the Master-slave mode: Press MENU to select SLnd. Then press Enter to start set-
ting. MAST, SL1 will be displayed. Press UP or DOWN to choose Master or slave, then press
Enter again to confirm your selection.
MAST: Choose the device as master
SL1: Choose the device as slave
Select between Auto Or Sound-controlled Mode: Press MENU to select ShNd. Press
Enter to start setting. Auto & SoUn will be displayed. Choose Auto for auto running of the
unit. Choose SoUn and the unit will follow the rhythm of the music. Press Enter to confirm
your choice.
Adjustment of sound sensitivity: Press MENU, select SEns and press Enter to start set-
ting. Use the UP and Down keys to adjust the sound sensitivity from 0-100. Press Enter to
confirm your choice.
This option is set to reverse the Pan direction. Press MENU, select Pan, press Enter to start
setting, UP and Down to select no or Yes, then press Enter to confirm your choice
This option allows the user to reverse the Tilt direction: Press MENU, select tiLt, press Enter
to start the setting. Use the UP and Down keys to select no or Yes, then press Enter to
confirm your choice.
DMX Address Mode
DMX Channel Mode

Master/Slave Mode

Auto or Music-controlled Mode

Sound Sensitivity

Pan Reverse
Tilt Reverse
3