Preparations For Work - ASKAYNAK Plasma 105 ULTRA Manuel D'utilisation

Input Cable Connection / Controller and Usage Features :
Before starting the machine, check input voltage, phases and frequency. Input voltage values to
be used are determined in "Specifications" sections of the user manual and in the plate located on
the machine. Make sure that the grounding of the cables connecting the machine to mains supply
are suitable and sufficient amount of current for normal operation of the machine can be supplied.
Cutting machine can only be connected to a mains which is protected with a 32 amperes delay
action fuse.
1- This machine has been designed as to work with 3 phase, 380 V (AC) and 50-60 Hz supply
voltage. It should only be operated on 3-phase grounded systems.
2- No mains plug is provided with the machine. Please select an appropriate plug for the mains
outlet to be used and connect the yellow-green cable in the mains cable to the grounding
terminal of the plug.
3- Never perform a mains supply connection and start the machine until there is a good
protective ground connection approved by a qualified electrician. Electric leakages
constitute death risk for human health.
Front and Rear Panel components :
1- Power Indicator Warning Lamp : Indicates that the machine is active.
2- Cutting Current Adjusting Knob : Adjusts the current value required for cutting.
3- Cutting Mode Selection Switch : Normal Cut : Switch position (1) , Grid Cut Mode: Switch
position (0).
4- Work Cable Connector : Work cable connection is made.
5- Plasma Cutting Torch Connector: Plasma cutting torch connection is made.
6- Pressure Meter : Indicates the air pressure being used.
7- Ready to Cut Warning Lamp : Indicates that the machine is ready for cutting.
8- Torch / Air Pressure Warning Lamp : In case of any fault on plasma cutting torch or an
abnormal situation on air pressure, it is activated to warn the operator.
9- Overload and Overheating Warning Lamp : Indicates that the machine entered into thermal
protection.
10- On/Off Switch : Controls the input of supply current to the machine.
11- Air Input Connector : Enables connection of compressed air to cutting machine.
12- Energy Input Cable : Supply cable that will be used for machine's mains connection.
44
Preparation for Work - 1