Installation And Operator Instructions - ASKAYNAK Plasma 105 ULTRA Manuel D'utilisation

Installation and Operator Instructions

Location and ambient conditions :
(Read this section well before installing and operating the machine)
For long economical life and safety operation, it is useful to take some simple precautions stated below:
1- Do not place the machine on a surface with a slope over 15° and do not operate on such surface.
2- Only use the plasma cutting torch given with the machine. Do not use any other torch.
3- Machine should always be operated in an environment having clean airflow and there should be
no obstacle that prevents ventilation or stops airflow. Do not cover the machine while operating
with paper, cloth or similar objects.
4- Dust and dirt may enter into machine. This should be reduced as much as possible. Do not
operate the machine in extremely dusty locations and environments having water, paint and oil
particles and also grinding dusts and abrasive gases in its atmosphere.
5- This machine has IP21S protection. Keep the machine dry as much as possible and do not place
it on wet ground or in puddles.
6- Plasma cutting machine should be used in places with good environment lighting and should not
be used in dark places. Also the plasma cutting machine has been designed to be used indoors
and is not suitable for using under sunlight, rain and snow. Do not use plasma cutting machine
to defrost pipes.
7- Place the machine far away from radio controlled devices. Normal operation of the machine
may interfere with this kind of devices nearby and in such case may cause injury or failure of the
equipment. Please read "Electromagnetic Compatibility" section included in this manual.
8- Do not use this machine at ambient temperatures below –10°C and above +40° C and in
environments having more than 70% humidity level. Heating tests have been performed in
ambient temperature and operation cycle has been determined with simulation at 40°C.
9- If the frame cover is opened and interfered by people who are not qualified for electrical
equipments, lifethreatening danger may occur. In case behaving on the contrary, be regarded as
accepting beforehand all potential negative consequences.
9- Thanks to 3 phase 380 VAC input power and its max 100 A cutting current, it enables cutting
low alloy steels up to 32 mm thickness without burrs.
Duty Cycle and Overheating :
The duty cycle of the machine is the percentage rate of cutting capability of the machine at the
specified cutting current to 10 continuous minutes without resulting in overheating or interrupting
the work.
The machine is protected against overheating by the basic protection provided. When this protection
trips, the warning lamp on the panel lights up. When the machine is cooled to the safe working
temperature, the warning lamp goes off and cutting is resumed.
Idle State :
As described in EN 60974-10 idle state is the operating state in which the power is switched on and
the cutting circuit is not energized.
There is idle state at this machine.
43