Safety In Cutting With Plasma Arc - ASKAYNAK Plasma 105 ULTRA Manuel D'utilisation

Safety In Cutting With Plasma Arc - 1

This machine has been designed to cut metal pieces,
Be sure that this machine should only operated by qualified personnel. Be sure that all
installation, operation, maintenance and repair procedures are performed only by authorized
personnel. Be sure to read user guide carefully before operating the machine. Failure to follow
the instructions included in the user guide may cause serious injury, loss of life and damage on
machine. Please read the warnings next to the symbols stated below. "Kaynak Tekniği Sanayi
ve Ticaret A.Ş." is not liable for any damages due to improper connection, storage conditions
and operation procedures.
WARNING: This symbol means that the instructions provided in the user manual
must absolutely be obeyed in order to prevent serious injuries, loss of life and
severe damage to the machine. Please protect yourself and those around you.
READ AND UNDERSTAND THE INSTRUCTIONS CAREFULLY: Read and
understand this manual before operating this equipment. Not complying with the
instructions given in the user manual may result in serious injuries, loss of life and
damages in the machine.
Cutting works should not be performed in a careless, pre-occupied, tied or
sleepless state.
Arc welding and plasma cutting works are safe application only when adequate
measures against any potential hazards are taken. If those measures are missed
or ignored, it might result in serious or probably fatal electrical shock, exposure to
excessive amounts of smoke and gases, arc radiation, fire or explosion etc. hazards.
Note: For detailed information on safety in welding and cutting, please read the
ANSI Z49.1 standard.
Protective Equipments:
The welding and cutting operators should wear clothing for protection against risk
of burning. Welding burns caused by the contact of the splashing sparks with the
skin are one of the most common risks encountered.
Skin burns is one of the most common risks encountered caused by sparks.
Woolen clothing should be preferred due to the resistance against fire. Because the
synthetic clothing melts when exposed to heat, they must not be worn.
The protective clothing should be kept away from grease and oil. Such materials
may increase the flammability.
The shirt and pant sleeves should not be folded. Because the sparks of molten
metal may fall in to the folds. The pants should be kept over the work boots and not
inserted in. Otherwise the sparks of molten metal may fall in to the boots.
36
and it cannot be used for any other purpose.