Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/17/2019 7:40:40 AM
1 - MANUAL ENGLISH
8.3.2 No Fuel
The stove ran out of pellets. Refill the hopper. Press "Reset" then "ON.
The burn pot holes are blocked. Remove the burn pot and clean it thoroughly.
The auger is jammed or auger motor failed. Go to the troubleshooting page on the LCD (see
Section 9.2 Testing Components) screen and test auger motors. If one of the motors is not
running check if motor is defective or if the auger is jammed.
Cambridge II and Osburn 3000C Pellet Stove Installation and Operation Manual
Stove Builder International Inc. | 48202 | Rev: May 31 2019 10:15AM | Uncontrolled Copy
(55 OF 91)
HOPPER VALVE
A
Screws
B
Valve and motor assembly
55
Page 62 of 864