Adjusting The Combustion Level (Heat Output) - SBI CAMBRIDGE II Mode D'emploi

Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/17/2019 7:40:40 AM
1 - MANUAL ENGLISH

5.1.5 Adjusting the Combustion Level (Heat Output)

The stove's input range goes from 10,500 BTU to 45,000 BTU. To change combustion level, select the
flame icon
INPUT RANGE MAY VARY ACCORDING TO THE TYPE OF PELLETS BEING USED.
Even though your stove can burn a large variety of wood pellets, we strongly recommend the use of
high quality pellets to obtain maximum performance out of your stove (see Section 5.2.1 Proper
Fuel). When using lower quality combustible, a restrictive venting system or using the stove in high
altitude, you may need to adjust the "PILOT SETTING ADJUSTMENT" and the "FUEL QUALITY
ADJUSTMENT". These two (2) settings are available from the "SETUP" page. See the following section
for more details.
TO OBTAIN OPTIMAL RESULTS MAKE SURE THE VENTING SYSTEM, HEAT EXCHANGER AND
EXHAUST CHANNELS ARE CLEANED BEFORE PERFORMING ANY SETTING CHANGES.
30
Stove Builder International Inc. | 48202 | Rev: May 31 2019 10:15AM | Uncontrolled Copy
(30 OF 91)
Press on the
pellet burn rate
adjustment button
on the main status page to display the "+" and "-" combustion level settings.
Cambridge II and Osburn 3000C Pellet Stove Installation and Operation Manual
NOTE
NOTE
Press + or -
to adjust
the burn rate
Page 37 of 864