BH bikes EASY MOTION EVO Manuel De L'utilisateur page 37

Description
System overcurrent
System overcurrent
TMM Sensor
Motor error
Motor sensor error
Battery low
Motor blocked
System overcurrent
Overheating
Protection against overheating
Communication error
Pedal error
Sensor error
Can Communication
System overvoltage
Torque sensor out of range
Over temperature
Below temperature
Current out of range
Torque sensor out of range
Speed sensor signal
Temperature discharging error
1/ 2 / 10 / 21
22 / 23 / 24
25 / 26
4 / 5 / 9 / 11 / 12
Error
Check that the connection between the motor and the con
01
troller is correct. If not, replace the controller.
02 Replace the controller.
Check that the connection between the TMM sensor and the
controller is correct. Check to see if the output of the TMM
03
sensor exceeds the normal range, it must be 0.1V-3.5V.
04 Check the motor or controller connector.
Check that the connection between the motor and the
controller is correct. If the sensor inside the motor is broken,
05 replace the sensor or motor with a new one. Check that the
connection between the motor cable and the controller is
correct. If not, replace the controller.
08 Check the battery level or replace it with a new one.
09 Motor stopped due to accident. Motor off.
If there is a bad contact bad between the controller and the
10
motor connector, replace it with a new one.
If the temperature exceeds the set value, the current gradually
11
weakens.
Enters into temperature protection mode, and the controller
12
stops.
13 Check the cable and the connector.
14 Take your foot off the pedal and switch on again.
15 Readjust the sensor.
Check connection motor and can converter. If error does not
16
dissappear, contact a BH dealer.
21
22
23
Restart the system. If error does not dissapear, contact a BH dealer.
24
25
26
27
28
15 3
U S E R M A N U A L
Observations
13 / 16 / 27 / 28
8
14
EN
3 7