Selection Of Pedal Assistance Level; Switch On And Off The Lights Of The Bicycle And The Backlight Of The Display Panel; Selection Of Display Information; Battery Level Indicator - BH bikes EASY MOTION EVO Manuel De L'utilisateur

EN
U S E R M A N U A L

3. Selection of pedal assistance level

The system has 5 levels of pedalling assistance (including the without assistance mode) To move through the
assistance modes, the user should press the (+) button to increase the level of assistance and the (-) button to reduce
the level of assistance.
By default, when starting the system, the assistance level will be the same level set before the system was last switched
off.
In 30% mode, the energy supplied is minimal. It provides higher autonomy with a lower assistance ratio. In 70% mode,
pedal assistance is maximum, and as a result the action ratio will be significantly reduced.
During a trip, a suitable selection of assistance modes considering the surface or pedalling conditions encountered will
provide you an optimum ratio between battery economy and pedalling comfort.

4. Switch on and off the lights of the bicycle and the backlight of the display panel

Press the (-) for 3 seconds, will switch on the retro illumination of the control panel. At this moment the lights on
indicator will light up:

5. Selection of display information

The display panel allows the user to see different information. The user may switch among the next options by pushing
the POWER button:
- Total distance (km).
- Total time (hh:mm).
- Average Total Speed (km/h).
- Trip distance (km).
- Trip time (hh:mm).
- Average Trip Speed (km/h).
- Range (TO GO km).
For reseting the trip information to zero, the user will push ON/OFF and (-) buttons for 3 seconds.

6.Battery level indicator

The battery level presents the following states:
26
increase
decrease
3 sec
Change information
push
Reset trip information
3 sec