Cycle Guide - Whirlpool WDT750SAHZ ECO Mode D'emploi

Masquer les pouces Voir aussi pour WDT750SAHZ ECO:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To add rinse aid, open the dispenser
lid by gently pushing in the center of
the lid with your thumb while lifting up
on the edge.
Pour rinse aid into the opening until the indicator level shows
that it is full.
Close dispenser by pushing down gently on the lid.
NOTE: For most water conditions, the factory setting will give
good results.
If you are experiencing poor drying performance, you may
want to try a higher setting. Turn the arrow adjuster to a
higher number to increase the amount of rinse aid.
5.
Select a cycle
Efficient dishwashers run longer to save water and energy, just as
driving a car slower saves on gas. Typical cycle time is approximately
2
/
hours but can take less or more time to complete depending
1
2
on selections.
This information covers several different models. Your dishwasher may not have all of the cycles and options described.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for
the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically
compensate by adding time, heat, and water as needed.
This cycle senses the load size, soil amount, and toughness of soil, to adjust the
cycle for improved cleaning, using only the amount of water and energy needed.
The Sensor cycle is automatically selected if you first press the Start button.*
Use for hard-to-clean, heavily soiled pots, pans, casseroles, and regular tableware.
This cycle is recommended for daily, regular, or typical use to completely wash
and dry a full load of normally soiled dishes. This dishwasher's government energy
certifications were based on the Normal cycle with only the Heated Dry option
selected.**
For fast results, the 1-Hour Wash will clean dishes using slightly more water and
energy. For improved drying, select the Heat Dry option.
NOTE: Some detergents are not recommended for short wash cycles, please refer
to your detergent packaging for more information.
This cycle quietly soaks dishes with an extended prewash which eliminates the
need to presoak dishes, saving personal time and effort. For optimal cleaning results
during the Soak & Clean cycle, add prewash detergent. Use this cycle for loads with
heavy amounts of dried-on or hard to clean baked-on food.
This is a specialty cycle that you select from the Whirlpool® app and download
to your dishwasher. Your dishwasher remembers this cycle until you replace it by
downloading another cycle from the Whirlpool® app.
(on some models)
*The government energy certifications are not based on this cycle. See the Normal cycle description for the government energy certification
cycle. Using the Sensor cycle may increase your energy usage.
**No other washing and drying temperature options were selected, and it was not subject to truncated testing. Rinse aid was not used, and there
was no detergent used in the prewash.
6.
You can customize your cycles by pressing the options desired. If you
change your mind, press the option again to turn off the option. Not
all options are available for every cycle. If an invalid option is selected
for a given cycle, the lights will flash. Adding options may increase the
cycle time.
7.
The indicator LED on the front right corner
Full
of the door panel will glow blue for washing/
rinsing, red for drying, and white for complete.
Add
Some models indicate cycle progress with
LEDs on the control panel such as Add Dish,
Washing, Drying, Clean, and Sanitized.
8.
NOTE: If needed, run hot water at the sink nearest your dishwasher
until the water is hot. Turn off water.
Push door firmly closed within 4 seconds of pressing Start. If door
is not closed within 4 seconds, the Start button LED will flash, an
audible tone will be heard, and cycle will not start.
IMPORTANT: If the door is opened for any reason after the cycle
is started (even during the Delay option), the Start button must be
pressed again.

CYCLE GUIDE

CYCLES
4
Select options
Follow the progress of your dishwasher
Start or resume a cycle
ESTIMATED
WATER USAGE
WASH TIME
GALLONS
W/O OPTIONS
(LITERS)
2:10 to 3:15
3.38 to 7.4
(12.8 to 28.0)
2:45 to 3:25
7.4 (28.0)
2:00 to 3:10
2.4 to 7.4
(9.09 to 28.0)
0:55 to 1:05
7.87 (29.8)
6:45 to 7:25
7.4 (28.0)
Variable
Variable up to
7.87 (29.8)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wdt730pahbWdt730pahwWdt730pahzWdt730pahvWdt710pahz

Table des Matières