KitchenAid KSMPEXTA Mode D'emploi page 9

USING THE PASTA PRESS
DISASSEMBLING THE PASTA PRESS
1
Turn Stand Mixer OFF and unplug.
Unscrew the pasta ring to remove.
If pasta ring is too tight to remove
by hand, slip the wrench side of the
3
combo tool over the grooves, and
turn as shown. Once the pasta ring
is off, pop out the pasta plate.
OPTIONAL: If desired, attach the next
pasta plate, using the directions in the
"Attaching the Pasta Press" section.
NOTE: Allow Stand Mixer to rest for at
least 1 hour after extruding 2 consecutive
pasta dough recipes.
Remove the Pasta Press attachment
2
from the Stand Mixer.
Use the combo tool hook to pull
4
the auger from the Pasta Press
housing.
IMPORTANT: After removing the auger
from the press housing, be sure to clean
any dried dough from the auger. See
"Care and Cleaning" for details.
USING THE PASTA PRESS | 9