Select And Start A Washing Programme - ETNA AFI8529ZT Notice D'utilisation

70
20 = approximately 20 g of detergent
30 = approximately 30 g of detergent.
2
3. All programmes with prewash need an
additional detergent dose (5/10 g) that
must be placed in the prewash detergent
chamber (2).
This detergent will be used during the
prewash phase.
When using detergent tablets; place the
tablet in compartment (1)
4. Close the lid and press until it locks in
place.
Detergent tablets from different manu-
facturers dissolve at different rates. For

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
1
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to ensure
the complete removal of detergent re-
siduals.
Use of combi detergent tablets
These products are detergents with a com-
bined cleaning, rinsing and salt functions.
They can also contain other different agents
depending on which kind of tablets you
choose ('3 in 1', '4 in 1', '5 in 1' etc.).
1. Check whether these detergents are suit-
able for your water hardness. See the
manufacturers instructions.
The refilling of the salt container and the
rinse aid dispenser are no longer neces-
sary. In this case the rinse aid indicator
light will always remain on when the ma-
chine is switched on.
2. Select the lowest setting for water hard-
ness and rinse aid dosage.
If the drying results are not satisfactory
we recommend that you:
1. Fill up the rinse aid dispenser with rinse
aid.
2. Set the rinse aid dosage to position 2.
If you decide to turn back to the use of
standard detergent system we advise
that you:
1. Fill up the dispensers for salt and rinse aid
again.
2. Adjust the water hardness setting to the
highest setting and perform 1 normal
washing programme without loading any
dishes.
3. Adjust the water hardness setting ac-
cording to the hardness of the water in
your area.
4. Adjust the rinse aid dosage.
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.