Complete Installation And Check Operation; Range Hood Use; Operating The Blower - Elica LI32WA Guide D'utilisation, D'entretien Et D'installation

Complete Installation and
Check Operation
1. Install grease filters. See the "Range Hood Care" section.
2. Check operation of the range hood blower and lights. See the
"Range Hood Use" section.
C
B
A
D
A. Halogen lamps
B. Lamps knob
C. Blower knob
3. If range hood does not operate, check to see whether a circuit
breaker has tripped or a household fuse has blown.
Disconnect power supply and check that the wiring is correct.
NOTE: To get the most efficient use from your new range hood, read
the "Range Hood Use" section.
E
D. Filter handles
E. Grease filter

Range hood use

The range hood is designed to remove smoke, cooking vapors and
odors from the cooktop area. For best results, start the hood before
cooking and allow it to operate several minutes after the cooking is
complete to clear all smoke and odors from the kitchen.
The hood controls are located on the center side of the range hood.
A
Operating the lights
1. Turn the light switch to the "LOW" position to turn the range hood
lights On.
2. Turn the light switch to the "HI" position to turn the range hood
lights at its higher intensity.
3. Turn the light switch to the "OFF" position to turn the range hood
lights Off.

Operating the blower

1. Turn the blower switch at "1" to turn the range hood on.
2. Turn the blower switch to the desired speed position.
3. Turn the blower switch to the "HI" position to turn the range hood
on High.
4. Turn the blower switch to the "OFF" position to turn the range
hood blower Off.
9
B
A. Lamps knob
B. Blower knob