Unpacking & Assembly 7 - Blue Clean AR 383 Manuel Du Propriétaire

Fig. 1
Fig. 2
Pump
Soft PVC High Pressure Hose
Fig. 3
93248_Modelo AR383.indd 7
U
NPACKING
• After unpacking the BLUE CLEAN POWER WASHER, lay
out parts and accessories. Familiarize yourself with the parts
in the package by comparing them to those listed on the
"PACKAGE CONTENTS" page.
• The BLUE CLEAN POWER WASHER requires some minor
assembly. You'll need a Phillips screwdriver to install the
accessory holders .
• Install the accessory holder on the back of your BLUE
CLEAN POWER WASHER (Fig. 1). You'll notice where the
accessory holder meets the back of the unit. You will see
GHA
posts and holes enable easy placement of the accessory
holder and easy tightening of the screws. Place the screws
in the holes provided on the accessory holder and screw
them in. Do not use a power screwdriver. When the screw
screwdriver. Do not over tighten.
• Using one of the supplied screws, install the small electric
power cord holder below the accessory holder so that the
"L" - shaped holder faces downward. The electric power cord
can now be wrapped around the accessory holder and the
bottom "L" - shaped holder while your power washer is not in
use (Fig. 1).
• Please refer to (Fig. 2) for accessory storage locations on
the accessory holder.
Soft PVC High Pressure Hose
• Screw the Soft PVC high pressure hose (clockwise) on the
back of the unit at the bottom (Fig. 3). The end of the hose
must be inserted into the water outlet far enough so the collar
can thread onto the outlet threads until hand tight. Do not use
pliers or vice grips to tighten. If it takes fewer than six or so
turns you have not properly tightened the Soft PVC high
pressure hose fitting. It is easier to position the power washer
Fig. 4
in front of you so to ensure that the threads are started correctly.
Failure to properly tighten the Soft PVC high pressure hose will
result in the hose slipping or popping off immediately upon
turning the unit on. Do not worry about damage if this occurs -
just reinstall and take extra care at screwing on the Soft PVC
high pressure hose fitting.
Connect the other end of the Soft PVC high pressure hose
•
to the spray gun by inserting the brass metal tip of the Soft
PVC high pressure hose into the fitting just ahead of the trigger
guard.
Comfirm the hose is
slightly on the hose. The hose is now securely attached to the
spray gun.
& A
SSEMBLY
It will lock into the spray gun with a "click" (Fig. 4).
locked into the spray gun by pulling
En - 7
2018/3/7 上午10:53