Kunzle & Tasin Bona Dual Edge Manuel D'utilisation page 17

Starting the Machine (Cont.)
5.
Locate the power supply. The
socket must be compatible
with the plug. Connect the
plug to the socket.
6.
Raise the discs so that the
machine is only resting on
the floor with its rear wheel.
Then, press and hold the
switch (A).
The switch must be kept pressed to operate the
machine. The machine gradually stops when the
switch is released or the power supply is interrupted.
7.
Keep the machine moving
when the discs are lowered
and in contact with the work
surface.
Bona Dual Edge Manual
8.
To stop the machine, raise the
discs so that the machine is
only resting on the floor with
its rear wheel. Then, release
the switch (A).
The disc does not stop
immediately! Take care not
to touch it with any part of
the body during this phase.
17
EN