Kunzle & Tasin Bona Dual Edge Manuel D'utilisation page 11

Prevention Measures for Users (Cont.)
Compliance with safety measures and warnings (cont.)
The sanding machine may create an explosive environment.
Cigarettes, cigars, pipes, lighters, pilot flames, or any other
source of fire may create an explosion if lit during sanding
operations. No sources of fire should be kept near the work
area.
Poorly ventilated work areas may create an explosive
environment when some combustible materials are present
in the atmosphere, such as solvents, thinners, alcohol, fuel,
some paints, wood dust or other combustible materials. Floor
sanding may cause various materials and fumes to ignite. Read sanding may cause various materials and fumes to ignite. Read
the manufacturer's instructions for each chemical product used the manufacturer's instructions for each chemical product used
and establish its combustibility. Always keep the work area
well-ventilated.
Striking nails when sanding may generate an explosion or fire.
Always ensure all nails are sunk before sanding surfaces.
Serious damage may occur if the power supply circuit trips
repeatedly or is undersized. Have the fuses, safety circuit and
power supply line checked by an authorized electrician.
Performing maintenance and/or repairing the machine when
it is not fully disconnected from the power supply may cause
death due to electrocution. Disconnect the power supply before death due to electrocution. Disconnect the power supply before
carrying out any maintenance and/or repair work.
The use of this machine on a circuit which is not grounded may The use of this machine on a circuit which is not grounded may
cause death due to electrocution. Never disconnect or disable
the grounding conductor. Consult an electrician if the ground
conductor is missing or it is suspected that the circuit is not
suitably grounded.
The use of this machine with a damaged power supply cable
may cause electric shock. Check the power supply cable
regularly for damage such as splitting or wear and tear.
DO NOT use the machine if the power supply cable is
damaged. DO NOT use the electric cable to move the machine.
Injury or damage may occur if the machine runs over the power
supply cable and it becomes damaged. Keep the cable away
from the lower part of the machine to avoid contact with the
abrasive.
Always keep the power supply cable raised above the machine.
The moving parts on this machine may cause serious injury
and/or damage. Keep hands, feet and loose clothing away from
all moving parts of the machine.
Performing maintenance or replacing the dust bag may cause
injury to the operator or people nearby if the machine is
connected to the power supply.
Bona Dual Edge Manual
11
EN