Milk Frother - SEVERIN SM 9667 Mode D'emploi

Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
The appliance should only be connected to
an earthed socket installed in accordance
with the regulations. Make sure that the
supply voltage corresponds with the voltage
marked on the rating label of the appliance.
This product complies with all binding CE
labelling directives.
Familiarisation
1. Lid
2. Operating button (automatic switch-
off)
3. Power cord with plug
4. Heating/stirring coil (for heating milk)
5. Whisk head
6. Base
7. Milk container
Important safety instructions
●
Before the appliance is used, the main
body as well as any attachments fitted
should be checked thoroughly for any
defects. If the appliance, for instance, has
been dropped onto a hard surface, it
must no longer be used: even invisible
damage may have adverse effects on its
operational safety.
●
This appliance is not intended for use by
any persons (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure
that they do not play with the appliance.
●
Do not leave the milk frother unattended
while in use.

Milk frother

●
Always observe the max-level marks
inside the container for the different
applications.
●
Caution: Overfilling the container may
cause danger from hot milk being forced
out; the housing surfaces become hot
during operation.
●
Caution: the lid must be fitted during
operation.
●
The milk frother must only be used on its
designated base.
●
The appliance must be used only on a
heat-resistant, level surface.
●
Do not allow the appliance or its power
cord to come into contact with open
flames or any hot surfaces such as hot-
plates.
●
Do not allow the power cord to hang
free; the cord must be kept well away
from hot parts of the appliance.
●
Always remove the plug from the wall
socket
- after use,
- in case of any malfunction, and also
- before cleaning the appliance.
●
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
●
This appliance is intended for domestic
use only and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Before using for the first time
Before the appliance is used for the first
time, or after extended periods of non-use, it
should be thoroughly cleaned as described in
the section General Care and Cleaning.
6