V-ZUG FORANO Manuel D'utilisation page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
press the "B" key.
Tasto Illuminazione (C) = Turns the lights on/off.
It is possible to adjust light intensity at three levels: high,
medium and low by pressing the "C" multiple times.
Timer key (D) = Set the appliance operational time for 15
minutes.
When the appliance is on speed 1, 2 or 3, the Timer function
is activated by pressing the "D" key. When active, the "E" LED
turns on. After 25 minutes the hood motor and lights shut off.
If the door is open, it is closed.
The Timer function cannot be activated with intense speed.
To deactivate the Timer function before it ends, press the
"A" key.
Filters LED (H) = After 30 hours of work, the LED indicator
of the filters turns on without flashing. In that event, the
anti-grease and long-lasting active carbon filters, if present,
must be cleaned. The function is reset (with the suction
hood off ) by pressing the "B" key for 5 seconds. Afterwards
the LED indicator of the filters will turn off and regulation
restarts from zero.
After 120 hours of work, the "H" LED starts to flash permanently.
This means that the standard active carbon filters must be
replaced, if present. The function is reset (with the suction
hood off ) by pressing the "B" key for 5 seconds. Afterwards
the LED indicator of the "H" filters will turn off and regulation
restarts from zero.
Clean air warning light (G) = The function makes it possible
to have a constant air recirculation in the room.
This is activated, with the hood off, by pressing the Timer key
"D" for 5 seconds. The motor switches on at speed 1 for 10 min.
each hour. The function is active when warning light "G" is on.
During motor operation the warning light "G" flashes.
The function deactivates by pressing any button with the
exception of the ones for the lights.
Cleaning LED (F) = During cleaning of the glass, to avoid
activating the controls by accident, they can be deactivated
for 30 seconds.To disable them, press the "A" key for about 3
seconds. When the function is active, the "F" LED starts to flash.
The function can only be activated with the hood off.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
- 20 -

Publicité

Table des Matières
loading

Table des Matières